neoTerra
  • Home
  • Blog
  • Woodland Gardens
  • Built-ins and Space Saving Design
  • How-To
  • Contact & Credits

Passive Solar Design I

6/30/2013

0 Comments

 
Our first step is to estimate how much heat we could theoretically collect through the windows.  In a future post I'll compare a couple of different types of glass to see how the Solar Heat Gain Coefficient (SHGC) affects the amount of heat gained and the potential $$ savings on heating.

To estimate the potential heat gain, I started with the 1993 ASHRAE solar tables for 32 degrees north latitude, which is fairly close to our actual location.  I got the tables from "The Passive Solar House", appendix 2 -table 14 and entered it all into an Excel spreadsheet.   The following table shows the BTU's collected by 1 square foot of glass each day by month.

Note that this is calculated data based on an optimal perfectly clear sunny day.
Picture
I know the table is a little hard to read.  The important info is that each square foot of south facing windows can potentially receive about 1700 BTUs per day during November, December and January.

However, most days are not perfectly sunny.   Most days have some clouds, haze or overcast that diminishs the solar energy. To get a better estimate of actual solar gain, we can use data from NREL that estimates the average % of sunlight that is actually received each month in different cities.   I used the % sunlight data for Atlanta to make the next table.  This shows the  BTUs per day adjusted for actual sunlight received.   In general, the average amount of sunlight is only about half of the theoreticl optimal clear day.

One interesting note is that the Fall tends to get more clear days than the Winter, so November gets more actual sunlight than December or January.
Picture

This is summarized in a nice graph from NREL.   The following chart shows the solar energy received for Athens, Ga.
Picture

The baseline design has about 475 square feet of south-facing glass.  If we used perfectly clear glass then we might expect to collect about 400,000 BTUs on an average day from October through February.   Unfortunately, a lot of that heat is blocked or lost by the glazing.   In the next post we will look at the effect of the glazing Solar Heat Gain Coefficient (SHGC). 
0 Comments



Leave a Reply.

    Archives

    February 2018
    January 2018
    December 2017
    September 2017
    July 2017
    June 2017
    March 2017
    November 2016
    October 2016
    September 2016
    August 2016
    July 2016
    May 2016
    April 2016
    March 2016
    February 2016
    January 2016
    December 2015
    October 2015
    September 2015
    August 2015
    July 2015
    June 2015
    April 2015
    November 2014
    October 2014
    September 2014
    August 2014
    July 2014
    June 2014
    May 2014
    April 2014
    March 2014
    February 2014
    January 2014
    December 2013
    November 2013
    October 2013
    September 2013
    August 2013
    July 2013
    June 2013
    March 2013
    February 2013
    January 2013


    Categories

    All
    Baseline
    Construction
    Cutting Cable
    Deck
    Driveway
    Electrical
    Energy
    Firewood
    Front Porch
    Fun With 80/20
    Fun With LEDs
    Home Automation
    Home Automation
    Ikea
    Insulation
    Kitchen
    Multi Splits
    Multi-splits
    Passive Solar
    Plumbing
    Science Projects
    Stairs And Railings
    Star Trek
    Steel
    Superior Walls
    Suspended Slab
    Temperature Sensors
    Widllife
    Woodland Gardens


    Follow Me on Pinterest

    RSS Feed

           
✕